Truview 1.1 > Lesson 1 - Introduction > Modes > Exercise

Objectives

In this exercise, you switch between the different modes available in TruView.

Step 1: Switch to Markup Mode.

Click the Markup tab to access Markup mode.

The tab appears approximately as shown below.

Figure 1 - The Markup tab.

Review the available options, which will be covered in a later section

Step 2: Switch to View mode.

Click the View tab

The tab appears as shown below.

Figure 2 - The View tab.

Review the available options, which will be covered in a later section

Step 3: Switch to Markup mode then back to the View mode using the right mouse button options.

Right-click in the window and select Markup from the resulting menu, as shown

Figure 3 - Right-click to access the menu

The system displays the Markup tab.

Figure 4 - The Markup tab.

Right-click in the window and select View/Hyperlink from the resulting menu, as shown

Figure 3 - Right-click to access the menu

Note that when you right-clicked, the menu displayed was different from the previous. The options available when you right-click depend upon the mode you are working in.

The system switches back to the View tab.

Step 4: Use the icons to switch modes.

Click to display the Markup tab
Click to display the View tab
Click to display the Measure tab

In the next lesson you will learn more about how to use each of the modes accessed in this lesson.

Objectives

End of Exercise